Description
- The Entry Arc: Do not turn down toward the bottom too early. Arc the car out exceptionally wide, kissing the outside wall on the straightaways.
- The Settle: Turn in smoothly and gradually. The Next Gen car relies heavily on underbody aerodynamics. If you jerk the wheel to force the car down, you will break the airflow seal under the car, causing a massive front-end slide (tight condition) or a sudden snap loose.
- Finding the Seam: In Turns 1 and 2, target the first or second asphalt seam from the bottom. In Turns 3 and 4, you can often run a bit higher or right down on the painted line depending on track temperature.
- Let it Roll: The center of the corners at Michigan feels like it lasts forever. Be incredibly patient. Your main goal here is to maintain your minimum corner speed (corner rolling speed) without scrubbing the front tires.
- The “Groove” Shift: Pay attention to where the grip is. Over a long race run on iRacing, the bottom lane can heat up and lose grip. Don’t be afraid to move up one or two lanes into the second or third groove where there is fresher asphalt to find extra side-force.
- The Launch: As you pass the apex and see the straightaway open up, begin smoothly unwinding the steering wheel.
- Wall Magnet: Let the car drift all the way out to the outside wall. Do not try to pinch the car down to stay low; you need every millimeter of the track to let the engine rocket down the massive backstretch and frontstretch.
- Lifting vs. Braking: In a qualifying trim or on fresh tires, you rarely need the brakes at Michigan. It is all about a smooth, timed lift of the throttle. Line up your entry with the visual distance markers on the outside wall and smoothly lift off the gas to roughly 10% to 20% (or a complete lift) to let the nose drop.
- The Brake Dab (Long Runs): As your tires wear out later in a run, give the brake pedal a very quick, light tap (about 5-10% pressure) just as you turn the wheel. This transfers weight to the front splitter, helping the car rotate through the center.
- Feeding the Power: Once the car hits the apex and points down the straightaway, roll back into the throttle. Do not stomp it down instantly. A progressive feed from 50% to 100% prevents the rear end from stepping out and burning up your right-rear tire.
- The Aero Wake: Michigan is heavily dependent on aerodynamic drafting. If you are trailing another Cup car, your front downforce will completely vanish on corner entry (Aero Push). You must lift significantly earlier when following a car, or you will wash straight into the outside wall.
- Side Drafting: On the massive straightaways, utilize side drafting to slow down your opponents. Pulling up right next to their rear quarter-panel dumps dirty air onto their spoiler, giving you a drag advantage into the next turn.
- Tire Management: Because Michigan is so high-speed, it absolutely punishes the right-front tire if you are too aggressive on corner entry, and the right-rear tire if you are greedy with the throttle on exit. Smooth steering inputs are the secret to saving tires over a full fuel run.
A balanced, race-ready Next Gen setup built for versatility, predictable rotation, and strong forward drive across multiple racing grooves.
The race setup is designed and taken into account for the fact that Homestead is a tough track. The car must stay perfectly balanced, perfectly straight, and perfectly planted. The teams that win here build setups that minimize drag, maximize platform stability, and give the driver confidence to attack the tricky bumps in the surface.
Qualifying Setup
A faster, more aggressive setup designed to maximize the grip of the newly paved surface and deliver the rotation, responsiveness, and single-lap speed needed for qualifying.
Setup Notes
Helpful notes from our builders covering braking technique, throttle application, preferred racing lines, lane versatility, and what to expect from the car as the tires and track conditions develop.
Homestead is a track that relies heavily on consistency and precise placement of the car, with Precision Speed Solutions you will have no issue with either of those two things!

Reviews
There are no reviews yet.